.22 Muzzle Brake 1/2x28, for .22 Cal, BLACK anodized, sized for TX22 slide

Description

This is a high quality, aluminum muzzle brake compensator.  It is made in the USA (Minnesota actually).
Shown on a Glock (if you have a .22 conversion kit), on Taurus TX22 and Taurus TX22 Competition; all pictured above.
Features include:
for .22cal
Sized to match the TX22, also works on TX22 Competition
threaded for 1/2"-28 tpi right handed threads (most common 9mm threads in US)
Slide width of 0.85"
Slide geometry matches the TX22 slide!!
Will work on any pistol with a threaded barrel for 1/2"-28 (but won't match the slide)
add just 0.84" to the length of the barrel (adds to what the threaded barrel sticks out the slide)
Made of 6061 Aluminum
Anodized hard coat type III, Black
held on with #10-32 x 3/16" nylon tipped set screws (so it will not scratch barrel threads) (included)
tighten set screws to 10-12 inch pounds
Set screws are tightened with a 3/32" allen wrench (included).  When tightened down the tops of the allen screws are below flush with the side of the compensator.  On screws this small about 10 inch pounds is all the tighter you want to get them.
You can loctite the set screws and the comp on if you want with temporary loctite (not included).  See my store for individual tubes if you need it!