-40%

1/2x28 9mm Muzzle Brake, Black Anodized, 10-degree, for Glock 17/19 width slides

$ 18.48

Availability: 11 in stock
  • Return shipping will be paid by: Seller
  • Item must be returned within: 30 Days
  • MPN: Does Not Apply
  • All returns accepted: Returns Accepted
  • Refund will be given as: Money Back
  • Material/Finish: Black Anodize
  • For Gun Make: GLOCK
  • For Gun Model: 17/19/26
  • Condition: New
  • Restocking Fee: No
  • Brand: None
  • For Gun Type: 17/16/26 and others
  • Type: Recoil Parts
  • Specific Part: Threaded Muzzle Brake

    Description

    This is a high quality, aluminum muzzle brake compensator.  It is made in the USA (Minnesota actually).
    Features include:
    9mm and .380 caliber
    vanes angled 10 degrees back to match some slide geometries
    threaded for 1/2"-28 tpi right handed threads (most common 9mm threads in US)
    Loosen and tighten with 2 screws for easy on/easy off
    COUNTER-BORED: this feature on the slide facing side lets the brake get closer to the slide to make the gap smaller!  (see picture of the side view)
    width is sized to match the Glock 17, 19, and 26 (1.00" wide - measure yours to see if it will match)
    flush with the top of the glock slide
    distance (or gap) from the front of the slide depends on your particular barrel but is reduced by up to 1/16" because of the Counter-bore.
    add roughly 0.89" to the length of the barrel (however far out yours sticks)
    Made of 6061 Aluminum
    Anodized black, hard coat type III
    held on with #6-32 x 3/8" socket head cap screws
    tighten set screws to 10-12 inch pounds
    This reduces felt recoil for competition, or duty.  Works better with higher grain/higher power loads (they have more gas to push back against the brake with).  In some cases, very light gamer loads will not cycle the action unless springs are changed out.
    Set screws are tightened with a 7/64" allen wrench. On screws this small about 10 inch pounds is all the tighter you want to get them.